Is hammerite oil or water based?
Is hammerite oil or water based?
Back then years ago they used to make hammerite oil based. Wire brush on metal, bit of sanding and slap hammerite on it worked. Today hammerite is water based and it isn’t a patch on the old stuff due to EU meddling.
How do you cover copper pipes?
One of the simplest and cheapest ways to cover up the copper pipes that connect to your radiator is by installing pipe sleeves. Pipe sleeves (or covers) simply slot over your copper pipework and gives a beautiful feeling of completeness to any radiator installation.
Can you cement over copper pipes?
Concrete in direct contact with copper would corrode it. 15mm copper pipes will need to move as they expand / contract with the heat produced.
Can I bury central heating pipes in the wall?
Hi, you can chase the pipes into the wall. (gives you the ability to sqare up those walls, you’ll love that when you come to do the tiling) There are no regs about burying hot cold or heating in walls, just gas! However isolating valves are required.
How do I clean copper pipes in my house?
Boil a cup of vinegar, a tablespoon of salt, and three cups of water in a large pot and add the copper item. Let it boil until the tarnish begins to come off, then remove the item, let it cool, polish, rinse, and dry.
Is it OK to plaster over copper pipes?
Yes. All copper pipes should be covered with something, especially if sand & cement is used. A bit of movement is better as you say. Some plaster doesnt do any harm to copper.
How do you cover copper pipes in concrete?
KevinD-A
- wrap hessian sleeving around all of the pipes ensuring they’re covered.
- buy a PVC duct tape such as 3m 3903i or 3m Super 33+ tape and wrap this around the pipes (separate question but can this be applied directly onto the copper pipes?)
How do you run copper pipes through studs?
drill the hole, and push the copper pipe through it until it hits the next stud. spend some time making sure it’s level and in line with the wall. make a mark around it with a pencil. find the center and drill.
Is it safe to drill into a stud?
One rule of thumb is to be especially careful when drilling into any walls that connect to your bathroom or kitchen—basically, any wall that’s likely to have pipes. “And unless you hit it where it passes through a stud, your drill bit will probably deflect off of the curved surface.”
How far apart are studs in older homes?
Before starting, there are a few things you need to know about walls: Typical stud spacing is 16 inches on center and even on older houses is rarely more than 24 inches on center; the majority of electrical boxes for switches and outlets are attached to a stud on one side; studs are on either side of a window; most …
How far apart are wall studs in a house?
16 inches