How much WHP does a stock WRX have?
How much WHP does a stock WRX have?
For a more realistic measure, the average “fast” stock turbo’d WRX will run in the area of 13.1-13.3 at around 103-104mph.
How much HP can stock STI handle?
Skim through the Subaru forums and you’ll find the question on so many STI owners’ minds, “how much horsepower can my EJ257 handle?” The answer is different for everyone, but the general consensus is that the 400-450whp range is when you might want to clear out the garage and get ready to pull a motor.
How much HP can a stock EJ25 block handle?
Your engine and can blow with as little as 300 whp with a bad tune. There are plenty of STIs out there making well over 400whp also, but the general concensus in this forum about how much WHP the STI block can handle is 400whp.
What happens turbo failure?
Usually when a turbo fails the pieces go into the intercooler along with a good amount of engine lube oil. If you do not shut it down quickly, smaller pieces get into the engine, again with engine oil. The turbo may not even cause damage, it may just stop for other reasons. No boost = no acceleration!
Is it hard to replace a turbo?
Replacing a turbocharger can be challenging. Modern car engine bays are compact and many turbo units are fitted in confined spaces where tool use is difficult. Some vehicle manufacturers recommend engine removal to replace a turbocharger. You’ll also learn some very important turbo fitting tips.
What causes turbo failure?
Most failures are caused by the three ‘turbo killers’ of oil starvation, oil contamination and foreign object damage. More than 90% of turbocharger failures are caused oil related either by oil starvation or oil contamination. Blocked or leaking pipes or lack of priming on fitting usually causes oil starvation.
Can a bad turbo cause rough idle?
If you can push the turbine or compressor far enough to the side to touch the housing, then it is worn, but probably still working. There is nothing about the turbo that can upset an idle. so there is nothing about a turbo that can upset the idle.
How do I know if I have a turbo?
All turbochargers should have an identification label or nameplate secured to the outside casing of the turbocharger. It is preferable if you can supply us with this make and part number of the actual turbo fitted to your car. Normally, you can identify the turbocharger by Model Name, Part Number and OEM number.
Can I drive my diesel without turbo?
So a diesel engine without a turbo doesn’t make much power and if you try to adjust the fuel or timing to add power, you can only go so far before the lack of air becomes a problem. This is why all modern diesels use turbochargers.
How long does it take to replace a turbo?
Installation of an aftermarket turbo kit can take up to 12 hours or more if you’re a slow worker.