How far apart do you put gutter brackets?
How far apart do you put gutter brackets?
As a rule of thumb, gutter hangers should be spaced a maximum of three feet away from each other. If you live in a cold climate, your contractor may recommend gutter hanger spacing of two feet apart to account for the additional weight from snow and ice.
How much should gutters overlap?
On the ground, assemble the gutter pieces and overlap the sections by 3 to 4 inches. Make sure that the top edge of each overlapping piece is pointed in the direction of the water flow.
How far should roof overhang gutters?
50mm
How do I calculate how many roof screws I need?
To find out the number of screws required to fix your roofing sheets to your battens, follow these simple instructions.
- Calculate the total Lineal Metres (LM) of your roof sheets by multiplying quantity by sheet length ordered.
- Next calculate the Square Metres (Sqr.
- Finally, multiply the Sqr.
How often do you put screws in a metal roof?
every 18 inches
How many screws are in a sheet of roofing?
You will still need four screws per sheet, but in one location it will be at the fourth corrugation as shown below.
How do you calculate roof sheets?
Divide the length of your roof area by 0.760 to determine the number of sheets you need. For example, a structure that’s 6.0m long is 6000 / 760 = 7.89 sheets.
What is the best screw for metal roofing?
Stainless steel screws should be used when screwing down aluminum metal roofs. ) Protect against corrosion and rust by using mechanically galvanized fasteners. Variety and choice matter. Instead of carbon steel screws use stainless steel or zinc aluminum cap screws.
Do you screw or nail plywood?
Answer: It is better to use screws on plywood instead of nails. Screws are more suitable for the soft plywood blocks since they can be removed more easily and do not cause splintering. You don’t have to worry about splitting the wood by using screws.
What are the best screws for plywood subfloor?
The proper steel screw sizes for securing 3/4-inch plywood to the floor joists are #8, #10 and #12 screws. The number refers to the thickness of the screw. Each is available in lengths from 1 1/4 to 3 inches. Typically, the 3-inch variety is used to secure plywood subfloors.
Can you use a brad nailer for underlayment?
Brad Nails or Finish Nails: It is best to use brad nails, and fasten the 1/4 luan plywood to the carcass. It will be the glue that will hold the plywood together for the long term. The nails just hold the plywood together while you glue. The best glue that I can recommend is Titebond II.
Do you have to use tongue and groove for subfloor?
For subflooring, you use tongue and groove plywood. The tongue and groove are only along the 8 foot edges. On the four foot edges, your seams will fall on joist tops, so no need for tongue and groove.