Can I put a light switch in the bathroom?

Can I put a light switch in the bathroom?

6 Answers from MyBuilder Electricians Light switches are not allowed in bathrooms it has to be a pull cord or a switch outside. Radiator pipes do not have to be bonded IF boiler is cross bonded and/or you have rcd protection on the fuseboard. Plastic fans do not have an earth as they are double insulated.

What height should sockets and switches be?

Part M of the Building Regulations (section 8) does not actually specify the required position but does go on to suggest that in habitable rooms this will be achieved by mounting the switches etc. between 45cm and 1200mm above the floor level (see below).

What is the maximum height of a lighting switch?

The height from the floor to the middle of the switch plate should not exceed 48 inches, and the minimum height should not be less than 15 inches. When the switch is over a counter that has a knee space, and the counter depth exceeds 20 inches, the maximum height of a switch is reduced to 44 inches.

Are sockets in skirting boards illegal?

Hi, no sockets should be left dangling in the air – it’s dangerous. All sockets, unless replacing current fittings, should be 50cm up the wall.

What is the minimum height for electrical outlets?

48 inches

Can receptacles and lights be on the same circuit?

Basic answer to your question of can a mixture of lights and receptacles be installed on a single circuit is yes. Check with local authorities on those limitations but yes it can be done. The groundwork for all AC circuits which are wired in what is known as parallel circuitry.

Should a refrigerator be on a 20-amp circuit?

Refrigerator Circuit A modern refrigerator requires a dedicated 20-amp, 120/125-volt circuit. You may currently have a smaller refrigerator plugged into a general lighting circuit, but during any major remodeling, a dedicated 120/125-volt circuit for the refrigerator should be installed.

Should kitchen outlets be 15 or 20-amp?

Requirement: Provide at least two 20-amp, 120-volt circuits to supply power to GFCI (Ground Fault Circuit Interrupter) 15 amp) for the higher power requirements found in kitchens. Think toaster ovens, blenders, and mixers.

Does a refrigerator need to be on a separate circuit?

Having the refrigerator on its own dedicated circuit is the recommended best practice for homeowners. Most refrigerators run between 3 to 6 amps, with that said, a refrigerator can spike at peak usage up to 15 amps. You should have refrigerators and freezers installed on a 15-20 amp dedicated 120 volt circuit.

How many amps is a small fridge?

For example, if you have a 120 Voltage and 240 Wattage then your mini-fridge shall have an Amperage of 2. With all this data, it appears that the majority of mini-refrigerators need about two amps, so are an allowable appliance at most colleges.

How many Watt is a fridge?

Conventional refrigerators typically have a starting wattage of 800-1200 watt-hours/day, and a running wattage of around 150-watt hours/day. Refrigerators are reactive devices that require additional power to start because they contain an electric motor, but significantly fewer watts to run as they remain on.

Does double door fridge consume more electricity?

First, double door refrigerator works in frost free mode, where electric fans are used to circulate cool air. Apart from that, double door refrigerator comes in large size of 235 to 295 liters capacity. This large size results in more power consumption. It requires around 30 to 40% more power or electricity.

How many watt is 1kVA?

900 watts