Can I drywall around my fireplace?
Can I drywall around my fireplace?
Drywall + Fireplace = House Fire Unfortunately, this is highly flammable and is not an appropriate or safe fireplace surround. The sheetrock had to be removed and replaced with any type of non-combustible surround – stone, tile, marble, or metal.
Do all gas fireplaces need to be vented?
Traditional gas fireplaces, like their wood-burning cousins, require an exhaust flue (vent) to remove harmful fumes from the home. When possible, an existing chimney is used to run a new flue, but in a home without a chimney, the high cost to install venting can sideline the project permanently.
Why do old houses have chimneys?
A chimney and fireplace can be a beautiful addition to any home. It was a means of keeping the house warm in the winter for older homes because central heat and air have not always been around. Homeowners used it for cooking in earlier years, as this country was settling.
How do you uncover a fireplace?
Opening up the fireplace
- Examine the chimney breast. If the chimney has been blocked up correctly, there will be a vent in the wall just above the skirting board.
- Removing the skirting board.
- Uncover the hearth.
- Tap the wall.
- Cut the bricks.
- Revealing the Fireplace.
- Check the draught.
- Chimney sweep.
Why do I have 2 chimneys?
A flue is a venting system, each system needs its own so If you heat your home with oil or gas and have a fireplace you would have two flues. Often times they are in one chimney so if you were to look down the chimney it would be separated into two venting system inside one chimney.
Can you build around a chimney?
No builder wants to leave 2″ of air space around the chimney, through the roof, blocked off with only fire stopping and roof flashing. Modern code makes it difficult to build chimneys with exposed masonry walls in contact with baseboards, flooring, and combustible ceilings.
Can drywall touch chimney?
“code requires 2″ clearance from a masonry chimney to all combustible material.” Yes, sheet rock can touch an edge if mounted perpendicular to the masonry chimney/fireplace.
How close can you build to a chimney?
It is widely known that masonry chimneys are required to meet the 3-2-10 rule. This rule means that they must extend 3 feet above the roof penetration on the shortest side, and the top of the chimney must be 2 feet higher than any portion of the building structure within 10 feet.
How much does it cost to put flashing around a chimney?
The average cost to replace chimney flashing is $300 to $1,500, depending on the chimney type….Chimney Flashing Repair Cost.
| Material | Replacement Cost |
|---|---|
| Metal Chimney | $300 – $500 |
| Stone and Masonry Chimney | $500 – $1,500 |
How long should chimney flashing last?
30 years