Popular 

Is Cadillac Northstar a good engine?

Joe Ford

Is Cadillac Northstar a good engine?

The original L37 features and performance produced 290 horsepower, with the engine topping out at around 300 horsepower. This shows that the Northstar engine produced some of the most powerful domestic front wheel cars on the market, and the Northstar engine and the performance are very good.

How long does a Northstar engine last?

Some have blown head gaskets as early as 50k, and some have gone 250k+. Its a question thats somewhat hard to answer. Of course, a motor with a properly repaired HG will keep going. The internal mechanicals will probably last ‘forever’.

How do you know when your motor is blown?

Check out some common signs of a blown engine:

  1. White Exhaust.
  2. Blue Exhaust.
  3. Knocking or Rattling Sounds.
  4. Coolant is Entering Your Engine Oil.
  5. Your Engine will not Start.
  6. A Piston that is Blown.
  7. Engine Block with a Hole in it.
  8. A Seized Engine.

Do I need to drain oil before removing head?

Re: drain oil to remove heads? The oil does not have to be drained but it is usually a good idea to change the oil after any internal engine repairs. You could drain it first and reuse it possibly. Going “inside the motor won’t be fun because the crankcase has to be split to change the cam or crank.

Do you have to drain the oil to change the valve cover gasket?

No, you don’t have to drain the oil to change the valve cover gaskets. That means BlueDevil Oil Stop Leak can act as a valve cover gasket sealer and stay in your engine oil until your next oil change and will not clog or harm your engine in any way.

How long does it take to replace head gasket?

six hours

How do you remove a cylinder head from an engine block?

  1. Step 1: Drain the oil and coolant.
  2. Step 3: Remove valve cover.
  3. Step 1: Rocker arm and rocker removal.
  4. Step 2: Remove the pushrods.
  5. Step 3: Loosen head bolts.
  6. Step 1: Remove the timing cover.
  7. Step 3: Remove the timing belt.
  8. Step 4: Remove the head bolts.

How long does it take to remove a cylinder head?

If you use a chemical sealant (and it works the first time), a few hours at most. If you have a garage make the repair by dis-assembling the upper half of the engine and replacing the head gasket; 2-3 days. If you perform the same procedure yourself; 2-3 days. You can “bodge” the repair and do it in less than a day.

How hard is it to change a cylinder head?

Removing the cylinder head is straightforward on pushrod engines , but more complicated on overhead-camshaft ones because you have to disconnect the timing belt or chain. Methods vary from one engine to another, so if possible consult a handbook for your make of car to verify all the details.