Lifehacks 

Why is TCL TV blinking?

Joe Ford

Why is TCL TV blinking?

On most TCL TVs, the standby light blinks anytime you press a button on your remote. This is to give you visual confirmation that your TV is receiving a signal from your remote. There is no way to prevent the light from blinking when you use your remote button.

Why does my TCL TV keep blinking?

This can be caused by your remote not being connected. You will need to check whether your remote is working fine, paired, and connected. If not, press and hold the pairing button on your remote to connect it to the TV. Once it is connected, your light will stop blinking.

How do I turn off the flashing light on my TCL TV?

Press on the TCL Android TV remote control, select System and then press OK. Press▲/▼ to select and highlight Advanced settings then press OK. Press OK on LED indicator: You can set the LED indicator to be flashing, off, or on when the TV is in standby mode. Press ▲/▼ to select your option, and then press OK.

How do I reset my TCL TV?

Click here for more information….If that happens, you can force the TV to reset by following the steps below:

  1. Using a straightened paper clip or ball-point pen, press and hold the recessed RESET button on the TV connector panel.
  2. Continue to hold the RESET button for approximately 12 seconds.
  3. Release the RESET button.

Does TCL TV have a reset button?

2nd way to do a factory reset TCL Smart TV Using a straightened paper clip or ball-point pen, press and hold the recessed RESET button on the TV connector panel. Continue to hold the RESET button for approximately 12 seconds. When the reset cycle completes, the status indicator comes on dim. Release the RESET button.

How do I reset my TV after a power outage?

Follow these steps to perform a power reset.

  1. Turn off the TV.
  2. Unplug the TV power cord from the electrical outlet.
  3. Let the television remain without power for 60 seconds.
  4. Plug the power cord back into the electrical outlet.
  5. Turn on the TV.

Why will my TV not connect to the Internet?

Update the TV software to the latest version. Perform a power reset on the TV. Reset the cable modem or router. Unplug the power cord of the modem or router from the electrical outlet for 30 seconds.

Why is my WPS button red?

The WPS button will blink red when a connection errors out or a session overlap is detected.