Where is OBD port Honda Accord?
Where is OBD port Honda Accord?
OBD connector location for Honda Accord VIII (2007 – 2015)
- The OBD2 socket is located under the steering wheel in the fuses box.
- OBD socket is near the hood lever.
- You can see the diagnostics port near the fuses.
How do you check the codes on a 1994 Honda Accord?
You can retrieve your Honda Accord’s trouble code(s) yourself by using inserting a jumper wire at the diagnostic connector located in the passenger side kick panel. Insert the jumper wire in the 2 PIN service connector between pins 1 and 2. You should also see a 3 PIN connecter. This is used for a trouble code scanner.
How do I find my engine code obd1?
To get the check engine codes to flash in your dash panel, use a jumper wire or a paper clip and connect terminals A and B of the diagnostic connector. Turn your ignition key on with engine off and the codes should start to blink. All codes should start with code 12 which is one long flash followed by 2 short flashes.
How do you read check engine codes?
Follow these 4 steps to insert and read the OBD scanner:
- Step 1: Locate your vehicle’s OBD port.
- Step 2: Plug your OBD scan tool into the connector.
- Step 3: Read the codes in the computer.
- Step 4: Record the codes that display.
- Step 1: Break down your code into sections.
Will AutoZone read codes?
Many drivers don’t realize that AutoZone, the nation’s largest auto parts chain, will do the following services free of charge: Read the codes on your check engine light. Test your battery’s voltage.
Why is my O2 sensor not ready?
If the oxygen sensor and catalyst monitors are also not ready, the culprit is most likely a weak battery. If your battery is more than four years old, replace it and re-run the Drive Cycle. It will suspend the Drive Cycle if it is not happy with any aspect of battery performance and/or charging system performance.
How many miles do you need to drive to reset computer?
100 miles