How do you reset the belt light on a 650 Arctic Cat?
How do you reset the belt light on a 650 Arctic Cat?
650 V2 BELT RESET SEQUENCE
- Turn key off. Disconnect belt failure switch. (2 wire orange & pink/blue) located on top of clutch cover.
- Turn key off.
- Reconnect the (2-wire orange & pink/blue) and the (4-wire).
- Turn key on belt light should no longer be flashing.
What does CVT mean on a Kawasaki Brute Force?
Belt Drive Transmission
What does CVT light mean?
Continuously Variable Transmission
What is a 2004 Arctic Cat 400 worth?
Values
| Suggested List Price | Average Retail | |
|---|---|---|
| Base Price | $5,399 | $1,500 |
| Options (Add) | ||
| Total Price | $5,399 | $1,500 |
What is limp mode in car?
Also known as ‘limp home mode’, limp mode is a security feature in cars which activates when the engine or transmission control unit picks up a fault. Once it detects a problem, limp mode will cause the less important parts of the car, such as air conditioning, to switch off, and the speed of the car will be reduced.
How do you reset the belt light on a Kawasaki Prairie 360?
These are on the clutch side, just above the belt snsor. Cut the key on for about 5 seconds, or untill you see the flashing lights momentarily blink differently. Then cut the key back off. Plug the grey and black plugs up the way they were.
How do you reset the belt light on a 2004 Kawasaki Prairie 700?
Un-plug the gray & black connectors and switch them with each other. Turn the key on and unplug the belt switch connector (2 pin). Turn the key off, then turn it back on to clear the memory.
How do you reset the belt light on a 2003 Kawasaki Prairie 650?
Early 2003 650 Belt light reset procedure.
- Turn the ignition switch OFF.
- Disconnect the belt failure switch at the 2-pin connector above the CVT cover.
- Disconnect both sets of 5 pin connectors located above the CVT cover.
- Connect these 5 pin connectors to their opposite pairs (grey to black and black to grey).