How do I connect my Sharper Image Speaker to my TV?

How do I connect my Sharper Image Speaker to my TV?

Plug the 3.5mm mini plug into the headphone jack of your TV. Plug the red and white RCA plugs into the Audio In jacks of your Transmitter Base. (Red=right, White=left) TIP: In most cases, if you connect the transmitter base to the headphone jack, the speakers on your television will automatically be muted.

How do I connect my Sharper Image wireless speaker?

Press and hold (about 5 seconds) the PAIRING button on the bottom of the receiver until the ON/ OFF indicator starts blinking. Pairing period is approximately 20 seconds. 3. Press and hold (about 3 seconds) the PAIRING button on the back of the base until the power indicator starts blinking.

How do I turn on my Sharper Image Speaker?

1. Connect the power cord to the speaker and plug it into a power source. 2. Long press the [ ] button to turn the speaker ON.

How do I connect my Sharper Image headphones to my Iphone?

Make sure that your earphones are powered off. Press and hold the MFB to power ON, the indicator light will flash RED & BLUE to indicate pairing mode. It will search for Bluetooth devices automatically. Using the Bluetooth menu on your device (phone, tablet, etc.), enable searching for nearby Bluetooth devices.

How do you sync Sharper Image wireless headphones?

Pairing the Earbuds Power the earbuds ON by removing them from the charging case or by pressing and holding the [Multi] button. After a moment, a voice will be heard, indicating that the 2 earbuds are connected to each other. One earbud will flash RED and BLUE, the other will intermittently flash BLUE….

Why are my wireless earbuds only playing in one ear?

Headsets may play only in one ear depending on your audio settings. So check your audio properties and make sure that the mono option is turned off. In addition, make sure that voice levels are balanced on both earbuds. The voice levels must be equal on both sides of your headset.

Why can I only hear out of one headphone PC?

If you only hear audio from the left side of your headphones, make sure the audio source has stereo output capability. IMPORTANT: A mono device will only output sound to the left side. Generally, if a device has an output jack labeled EARPHONE it will be mono, while an output jack labeled HEADPHONE will be stereo….

Why does only one speaker work on my computer?

It sounds like your balance might be off. Open the Sound applet from the Control Panel and click the Configure button for your default sound device. Then go to the Levels tab and click on the Balance button. Adjust the sliders so that the balance is even on both the left and right speakers.

How do I fix the short wire in my headphones?

Insert your headphones or earphones into your phone or musical device and play some music. Hold a part of the wire near the earpiece and bend or jiggle it. Make your way to the other end of the wire and jiggle every inch until you hear the headphone sound gets cut out….

Why do my headphones cut in and out?

Signal issues There could be several reasons for signals dropping. For example, long distance between the devices, headphones turning old, or low range of Bluetooth headphones. These issues cause signals issues, and audio within the Bluetooth device starts shaking….

How do I stop my headset from cutting out?

Connect the headset to a different USB port or on a different computer and check the issue occurs. Method 2: Disable speakers and other audio devices temporarily: You can temporarily disable the other devices from the playback devices, enable only the headset and also set headset as the default device.