How long should my arrows be for a 29 inch draw?

How long should my arrows be for a 29 inch draw?

You're using a compound bow with 29” draw, then the arrow length for 29” draw should be 29” – 1.5” = 27.5”. For most modern bow and riser, it is still acceptable. The arrow will likely to stay on the arrow rest, which is vital.

Can arrows be too long?

The longer the arrow, the weaker the spine. So to answer your question, yes an arrow can sometimes be too long. Longer arrows can also lessen your FOC (Front Of Center) percentage, which may cause less than optimal broadhead flight. It can't hurt if it's too long if it's shoots well for you.

What is the difference between 340 and 400 arrows?

340, 400, 500 is the amount of deflection of the same weight added to each arrow. 340 is less than 400 and so on.

How do I know what arrows to buy?

If you want to target practice, you want the arrow to weigh in total (shaft, vanes, insert, nock and field point combined) around 5 to 6 grain per pound of draw weight. So if your bow has 60 lbs. of draw, you want to use arrows that weigh in total between 300 and 360 grain.

How far should an arrow go past the rest?

The best safety practice is to make sure your arrows sit at least 1" beyond your arrow rest when the bow is at full draw. A little bit of extra arrow length gives the arrows an important margin of safety.

What does Arrow size 400 mean?

Drawing an arrow that's too short is dangerous because it may slip off the bow. … Carbon arrows also are labeled to indicate their spine deflection. The most common spine sizing values are 340, 400, and 500. As with combination arrows, a smaller number means the arrow has a stiffer spine.

What is it called when you shoot a bow without an arrow?

"Dry fire" is a term used to describe the act of shooting a bow without an arrow properly nocked on the string. Most of the time a dry-fire happens by accident.

What might happen if an arrow is too short for the bow?

Bending, known as "archer's paradox," occurs when an arrow is released from the bow. … Spine strength must be matched to bow draw weight. If your arrows are too lightly or heavily spined for your bow, the "archer's paradox" movements will be extreme, resulting in poor arrow flight and loss of accuracy.

How long do Arrows last?

Most hunting arrows can last 20, 30 or even 40 years or more! The lifespan of an arrow is based on the hunters ability to care for it. Keep your arrows out of the sun and don't shoot them into hard surfaces that can break them. Shooting a damaged arrow is really dangerous and can impale the bow arm of the archer.

Does arrow length affect accuracy?

Your target should be thick enough that no arrows will pass through it. the shorter arrows are going to be more accurate than the longer arrows but they did not explain why. … Longer arrows flex more. This means it is harder to get an accurate shot with too long of an arrow.

What is the disadvantage of an arrow that is too long for the bow?

Arrows with a diameter smaller than the grooved track in the barrel of the crossbow will sit too low in the barrel's flight groove. Conversely, arrows with too large a diameter will sit too high and create misalignment between the nock and bowstring. Such a misalignment can cause a dry-fire or erratic arrow flight.

What length arrows for 28.5 draw?

It is pretty common for people to shoot the same length arrow as thier draw, like you stated 28.5 inch draw, 28.5 inch arrow. It just makes it easier to remember. However I would just make it 28 inches even so it was easier. Remember though when you shoot a longer arrow it will be weaker in spine.

What is a good arrow weight for whitetail?

I think a good average hunting arrow should fall in the 6 to 8 grains per pound of bow weight, with lighter bows maybe even closer to 9 to 10 grains per pound. A typical 60-lb. bow should be in the 360- to 480-grain range, a 70-lb. bow in the 420- to 560-grain range.

What length arrows should I use?

Arrows should be at least 1.5" – 2" beyond the back of the riser at full draw. Arrows should be at least 1.5" – 2" beyond the back of the riser at full draw.

What size arrows do I need for a 30 inch draw?

Arrow Spine. The spine rating of an arrow is simply a measurement of its stiffness. The same Easton arrow comes in a variety of stiffness: the lower the number, the stiffer the arrow. For example, a 330 arrow is stiffer than a 500 spine arrow.

Why does my arrow wobble?

It's not the rest, it's the tune of the bow or the arrow. Just because a whisker bisquit causes 360 degree friction to straighten an arrow out doesn't make it "THE ANSWER". The answer is start at square one and tune it. Make sure you're shooting the right arrow/broadhead for your specs.

What size arrows for a 26 draw?

If you draw a compound bow back to full draw, the official draw length is found by measuring the distance from the nocking point on the string, in a line perpendicular to the center line of the bow, to an imaginary point above the pivot point of the grip, plus 1.75 inches.

What are FMJ arrows?

Since their inception, micro-diameter Full Metal Jacketed carbon arrows have been a cut above all other hunting arrows. From deeper penetration, improve aerodynamics, and higher levels of downrange speed and KE, FMJ provides the most deadly penetration for all big game hunting.