Why do my jump rings keep opening?
Why do my jump rings keep opening?
Jumprings that have been pulled apart to open, rather than twisted, are difficult to reclose snugly. Finally, if jumprings just aren't fitting together snugly no matter how much you try to bend them back and forth, you can try the loop-closing pliers to close the jumpring tightly.
Can I solder silver with a soldering iron?
CAN I SOLDER STERLING SILVER WITH A SOLDERING IRON? A soldering iron will not be suitable for soldering sterling silver. You will need to use a gas torch to achieve the correct temperature.
How do you protect stones when soldering?
To avoid endangering the stone while soldering it is often packed in some cooling or refractive material, Kool Jool® and similar proprietary products, wet matted paper towel and so on to protect it. Another material used to protect gems is paper clay, a product found in many craft shops and originating in Japan.
What is a jump ring for jewelry?
Jump rings are metal rings where the ends meet but are not welded or soldered together. Jump rings are the components used in making chainmaille, as well as for connecting jewelry components together such as attaching a clasp to a chain or cord.
What is a jump ring used for?
Jump rings are used in SO many different jewelry projects. Their basic use is to connect two components together. They are especially useful if one of the components such as a charm or clasp has a closed loop connector. A jump ring opens and closes very simply with a pair of pliers, as will be demonstrated below.
Can I use a soldering iron for jewelry?
Because it melts at a low temperature, you can apply soft solder with an electric soldering iron or gun. Warning: If you use a tin-based soft solder on a piece of sterling silver jewelry, you will never be able to use a torch or hard solders on it.
How do you solder a jump ring with a soldering iron?
In terms of jewelry making, soldering is joining two pieces of metal with another metal alloy called solder by using heat (a torch) and flux. Many metals used in jewelry making can be soldered, including sterling silver, fine silver, brass, copper, gold, and gold filled.
How do you use a jump ring?
Always open your jump rings by twisting them open to the side NOT by pulling the ends apart. You will hold a pair of pliers in each hand, grasp the ring on either side of the opening and twist in opposite directions. You can also use a jump ring tool in place of one pair of pliers.
Can you solder stainless steel?
Can You Solder Stainless Steel? The short answer is yes, as long as you use the correct heating source, solder, and flux. When soldering stainless steel you should not use normal soldering flux. You will need a high activity acid flux because of the amount oxides on the surface of stainless steel.
What is cold soldering on jewelry?
How to Solder Gold & Silver Without Heat. Experienced jewelers and manufacturers know that typical “cold soldering” is more accurately described as “resistance soldering.” Cold soldering tools, like the popular ColdHeat Soldering Pen, have a split tip with electric current running through each point.
What kind of flux is used for jewelry?
This is called the flow flux. Batterns and Handy Flux are the top choices. Boric acid and water is also used. Batterns Self-Pickling Flux is used for hard soldering (solder that melts at a high temperature) of gold, silver, and platinum.
What are jump rings made of?
Jump rings are (usually metal) rings used to make chains, jewelry, and chainmaille. They are made by wrapping wire around a mandrel to make a coil, then cutting the coil with wire cutters to make individual rings.