What fuse to use for fog lights?
What fuse to use for fog lights?
Splice a red wire from the headlight wire to the relay terminal “30.” This line needs a 10-amp inline fuse, so be sure and wire one in. The final terminal on the relay is numbered “87.” This terminal will carry power to the fog lights. The fog lights each have two wires, one for ground and one for the 12V power.
How do you connect fog lights to batteries?
Attach a yellow connector to the black wire (ground wire) at the fog lights, then attach it to ground. Put a yellow circular wire connector on the last wire that goes to the battery and attach it to the positive post of the battery. The lights can be turned on or off safely at any time.
How do you connect fog lights to parking lights?
How to Run Fog Lights on Parking Lights
- Disconnect the positive and negative battery cables using the wrench set.
- Remove any protective wire loom from the parking light wires and locate the positive wire for each parking light.
- Twist the positive wire for the fog light to the positive wire for the corresponding parking light on that side of the vehicle.
Can you add fog lights to a car?
Upgrading your fog lights, or adding fog lights to a car that doesn’t already have them, can greatly improve visibility and safety. Most vehicles have fog lights located on the front bumper. Some drivers may choose to install fog lights on the grill or on a rack above the front of the vehicle.
Do you need a relay for fog lights?
Generally, a relay is necessary unless your are planning on ghetto-rigging your foglights hard-wired to the battery (you know, the way that people do it even with a relay but that never gets switched off- so your fog lights will come on with no other lights on AND so that you’ll be sure to leave them on and come back …
Does a light bar need a fuse?
You are correct, the light bar will draw 5.4 amps at 13.8 vdc or 6 amps at 12 vdc. According to the switch specs, there is no integral fuse.