How do you reset the tire pressure light on a 2010 Dodge Avenger?

How do you reset the tire pressure light on a 2010 Dodge Avenger?

Drive the car at 50 mph for about 10 minutes. Without starting the car, turn the key to the “On” position. Press the TPMS reset button and hold it until the light blinks three times, then release it. Start the car and let it run for 20 minutes to reset the sensor.

What kind of oil goes in a Dodge Avenger?

Engine Oil

Viscosity:	5W-20 (All TEMPS)
Capacity:	4.5 quarts. . (with filter)After refill check oil level.
Torque:	30 ft/lbs (Oil Drain Plug)

How do you change the oil on a Dodge Avenger?

Depress the Accelerator (“Gas”) pedal down 3 times within 10 seconds. 3. Turn off the ignition switch. The “Change Oil” warning light should not be displayed the next time you start the engine.

How do you reset the oil change light on a Dodge Avenger?

Oil service reset Dodge Avenger, 2008, 2009, 2010. Fully depress the accelerator pedal slowly three times within 10 seconds.

How many quarts does a Dodge Avenger take?

5.5 Qts

How do you reset the change oil light on a 2012 Dodge Avenger?

How to Reset Oil Change Required Light on the Dodge Avenger

1. Turn the ignition to “On” where the electronics are on, but the engine is off.
2. Gently press the gas pedal all the way down three times within a ten second interval.
3. Turn the ignition to “Lock“.

How do you reset the check engine light on a 2014 Dodge Avenger?

2007-2014 Dodge Avenger Oil Change Required Light Reset: Turn the ignition key to position “ON” without starting the engine, If your Dodge Ram has push-button start, press the “Start” button twice without touching the brake pedal. fully depress accelerator pedal slowly three times within 10 seconds.

How do you reset the oil change light on a 2014 Dodge Avenger?

2007-2014 Dodge Avenger Oil Change Required Minder Light Reset

1. Stop the vehicle and turn the ignition switch to the RUN position without starting the engine.
2. Fully depress the GAS PEDAL slowly three times within 10 seconds.
3. Turn the ignition off and start the engine to verify the indicator has been reset.

How do you reset the computer on a 2008 Dodge Avenger?

You can do a computer reset by disconnecting the battery cables then hold the cables together for 1 minutes, then reconnect to the battery.

Where is the ECU fuse on a 2008 Dodge Avenger?

In the 2008 Dodge Avenger, You’ll find the fuse box that controls most interior components underneath Your hood. It’s to the far right side of the engine compartment, near Your air filter assembly.

How do you change the oil on a 2008 Dodge Avenger?

How do you change the oil on a 2008 Dodge Avenger?

1. Getting Started.
2. Open the Hood.
3. Find Oil Drain. Locate the oil drain plug underneath the vehicle.
4. Drain Oil. Set up the workspace, drain oil and replace plug.
5. Find Oil Filter. Locate the oil filter.
6. Remove Filter. Position drain pan and remove the oil filter.
7. Replace Filter.
8. Remove Oil Cap.

How much oil does a 2012 Avenger take?

The oil capacity for the 2012 dodge avenger 2.4 L is 4.5 Quarts with filter.

What type of oil does a 2012 Dodge Avenger take?

Synthetic

What kind of oil does a 2013 Dodge Avenger take?

How much oil does a 2013 Dodge Avenger take?

The 2013 dodge avenger takes 4.4 quarts of synthetic motor oil after its been drained and the filter changed.

What type of oil does a 2008 Dodge Avenger take?

How do you check the transmission fluid on a 2008 Dodge Avenger?

Transmission Fluid Level Check Dodge Avenger (2008-2014)

1. Getting Started – Prepare for the repair.
2. Open the Hood – How to pop the hood and prop it open.
3. Remove Dipstick – Access point for transmission fluid.
4. Check Level – Insert dipstick and pull it out to determine level.
5. Add Fluid – Determine correct fluid type and add fluid.

What kind of oil do you put in a 2014 Dodge Avenger?

What kind of oil does a 2009 Dodge Avenger take?

Recommended oil for my 2009 Avenger

Product Name	Capacities
Signature Series 5W-20 Synthetic Motor Oil	With filter 5.5 quarts After refill check oil level.
XL 5W-20 Synthetic Motor Oil	With filter 5.5 quarts After refill check oil level.
OE 5W-20 Synthetic Motor Oil	With filter 5.5 quarts After refill check oil level.

How do you check the transmission fluid on a 2013 Dodge Avenger?