Articles 

How do I program a GE universal remote to a Sylvania TV?

Joe Ford

How do I program a GE universal remote to a Sylvania TV?

Universal Remote Control Programming Instructions for Sylvania TV

  1. Enter Setup Mode. Press and hold down the SETUP button on the remote until the red light on the remote turns on.
  2. Press the device type button.
  3. Enter the device code.
  4. Tests the results.
  5. Repeat this process for your other devices.

How much is a Control 4 Remote?

The Neeo is a touchscreen remote control that lets Control4 customers access their smart home devices and adjust settings, schedules, music playback, and more. It’s available in either black or silver through Control4 dealers starting today for $600.

How do I reset my control 4 NEEO remote?

Q: How do I power cycle (reboot) the Neeo Remote? A: You can either: Press and hold the power button until the power menu displays, then tap Restart, or. Press and hold the power button until the remote turns off, then press the power button again turn it back on.

How do you reset a Control4 controller?

Press and hold the ID button for five seconds. The controller will reset. To reset the controller network settings to the default: 1 Disconnect power to the controller. 2 While pressing and holding the ID button on the back of the controller, reconnect power to the controller.

How do I find my control 4 IP address?

How to find out your Control4 router gateway IP

  1. Open a terminal window (Shortcut on some distros: ctrl + alt + t )
  2. You will be presented with your Control4 router’s IP address.

How do I reset my sr260 remote?

  1. take on battery half way out.
  2. press “red 4” button and “0” same time.
  3. keep pressing and push battery in.
  4. keep pushing buttons and wait till remotes buttons start to blink (5- 10 sec.)
  5. wait till the end of the process (or leave it alone for 10 min)
  6. re identify. Link to post. Share on other sites.

How do I connect my remote control 4 to my Apple TV?

As long as your C4 controller not too far from the Apple TV, you can connect a cable with an IR transmitter to the controller and glue the transmitter to the Apple TV’s IR sensor. Then your C4 dealer needs to configure your C4 controller to control the Apple TV via that IR connection.